Products > Cement-Based Adhesive Mortars

MATOX 208F – cement adhesive for EPS (Standard)


MATOX 208F cement mortar is designed to insulate external walls of the buildings. 205S mortar is used for fixing EPS-boards. Workability of prepared mortar is over 90 minutes.


Preparation

Stir MATOX 208F mortar into clean, clear water until it is completely free of lumps. Approx. 7-8 l of water are needed to prepare 25 kg (mixing ratio 3:1). MATOX 208F adheres to all solid, load-bearing, clean, dry and moist surfaces free of substances which ca cause separation. Remove any coatings with inadequate bearing strength.

Applications

The ready mortar should be applied with a trowel along the board edges forming a strip of about 1-3 cm wide and a few spots with the diameter of 8 cm. The boards should be fixed tightly one at the other in one surface with the preservation of “brick like manner” of vertical connection. The ready mortar of 5mm-thick layer should be spread along the surface of the boards by means of a smooth long steel float. The glass fibre mesh should be applied on the fresh mortar (10-cm overlaps), and then the second 5mm-thick layer should be applied and smoothed evenly so that the glass fibre mesh should not be visible.

208f cementni lepak za stiropor

Specifications

Obradivost/Workability: > 90 min.
Potrošnja/Coverage: 6-9 kg/m² DEMIT
Mešanje/Mixing ratio: 7-8 litara vode / 25kg
Klizanje/Creep: < 0,5mm
Pakovanje/Packaging: vreća 25kg / 25kg sack
Skladištenje/Storage: 12 meseci / 12 months

Tip

Use MATOX 208F only at temperatures of +5 °C to +25 °C

Related products: